Wrap Buddies is your new gift wrap sidekick as it
has a handy clamp that attaches to the edge of almost any table to hold a roll
of paper in place with ease. It also has a built-in tape dispenser, keeps paper
in place, while cutting, adjusts to fit any roll of wrapping paper, and fit
together for easy storage.
My
Opinion: I know I have issues wrapping at Christmastime as that is when I do
the most and I always cut the paperless then straight and then I have to
compensate elsewhere to make it look good and presentable. This helped me to
not have that happen and it really does hold a lot to keep you from losing the
tape, gift tags, ribbon etc. It takes up little room in the draw too.
About
Them: Wrap Buddies were born in 2008 after Bret Wortman became
frustrated during a gift wrapping session when his rolls of wrap kept falling
on the floor, and wrapping on the floor hurt his knees and back too much. The
first Buddies were made of wood and fit one tabletop precisely, with no
adjustability. Several years later, the 3D printing revolution made it possible
to prototype designs that adapted to multiple table thicknesses, and we were
off to the races! We soon incorporated a tape dispenser too on each end to
eliminate the search for the elusive tape problem and suddenly, gift wrapping fun again.
Disclaimer:
I received one or more of the products or services mentioned above for free in
the hope that I would mention it on my blog. Regardless, I only recommend
products or services I use personally and believe will be good for my readers.
I am disclosing this in accordance with the Federal Trade Commission's 16 CFR, Part 255: "Guides
Concerning the Use of Endorsements and Testimonials in Advertising.
No comments:
Post a Comment